Grandstream GVC3202 Manual Del Usuario página 5

5. Install screw Type 1 to each of the two
holes on Part B, as highlighted on the
right.
2 X Screws
Type 1
6. Manage the wire harness with the Hook-and-loop fastener on wall mount
bracket Part B.
INSTALLING BRACKET TO MOUNT THE GVC3202 ON
WALL:
1. Locate the wall mount bracket in the package and identify Part A and Part B.
Detach Part A from Part B by sliding Part A out.
Slide Part A outwards
5
Built-in
Screw
Silicon
Stopper
Part A
Locating Pin
Four holes for wall
mount, using screw
Type 3
Part B
2. On wall mount bracket Part B, there are four holes on it for screw Type 3. Align
Part B against the wall where you would like to place the wall mount.
3. According to the position of the four holes on Part B, locate the corresponding
spots on the wall and drill the holes.
4. Fit the four bolts into each hole on the wall. Please make sure the glossy side
is placed outwards. See figure below.
5. Mount the wall mount bracket Part B
to the wall. Then put the four screws
Type 3 into each bolt.
6. Tighten the screws so that Part B
can be securely placed against the
wall.
7. Slide the wall mount bracket Part A
into Part B, as indicated in the above
arrow.
6