Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
About This Guide
The ÉPIX Flex 20 Quick Reference Guide (QRG) has basic product information such as mounting and technical
specifications. Download the User Manual for the ÉPIX Flex Drive from
Disclaimer
The information and specifications contained in this QRG are subject to change without notice.
LIMITED WARRANTY
FOR WARRANTY REGISTRATION AND COMPLETE TERMS AND CONDITIONS PLEASE VISIT OUR WEBSITE.
For Customers in the United States and Mexico: www.chauvetlighting.com/warranty-registration.
For Customers in the United Kingdom, Republic of Ireland, Belgium, the Netherlands, Luxembourg, France, and
Germany: www.chauvetlighting.eu/warranty-registration.
Chauvet warrants that this product shall be free from defects in material and workmanship under normal use, for the
period specified in, and subject to the exclusions and limitations set forth in the full limited warranty on our website. This
warranty extends only to the original purchaser of the product and is not transferable. To exercise rights under this
warranty, you must provide proof of purchase in the form of an original sales receipt from an authorized dealer that shows
the product name and date of purchase. THERE ARE NO OTHER EXPRESS OR IMPLIED WARRANTIES. This
warranty gives you specific legal rights. You may also have other rights that vary from state to state and country to
country. This warranty is valid only in the United States, United Kingdom, Republic of Ireland, Belgium, the Netherlands,
Luxembourg, France, Germany and Mexico. For warranty terms in other countries, please consult your local distributor.
Safety Notes
These Safety Notes include important information about installation, use, and maintenance.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
•
DO NOT look at the light source when the product is on.
•
CAUTION: When transferring product from extreme temperature environments, (e.g. cold truck to warm humid
ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure, allow
product to fully acclimate to the surrounding environment before connecting it to power.
•
CAUTION: This product's housing may be hot when lights are operating.
•
Mount this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces.
•
DO NOT leave any flammable material within 50 cm of this product while operating or connected to power.
•
USE a safety cable when mounting this product overhead.
•
DO NOT submerge this product (IP65). Temporary outdoor operation is fine.
•
DO NOT operate this product if the housing, ports, or cables appear damaged.
•
DO NOT connect this product to a dimmer or rheostat.
•
ONLY connect this product to an ÉPIX Flex Drive, an ÉPIX Flex Boost, or another ÉPIX Flex 20.
•
In the event of a serious operating problem, stop using immediately.
•
The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.
•
The minimum ambient temperature is -4 °F (-20 °C). Do not operate the product at lower temperatures.
Contact
Outside the U.S., United Kingdom, Ireland, Benelux, France, Germany, or Mexico, contact your distributor to request
support or return a product. Refer to
What is Included
•
ÉPIX Flex 20
•
Installation Kit with 10 Bracket Sets
•
Termination Kit with End Cap and Silicone Glue
•
End Plug
•
Quick Reference Guide
1
QUICK REFERENCE GUIDE
Contact Us
at the end of this QRG for contact information.
www.chauvetprofessional.com
ÉPIX Flex 20 QRG Rev. 1
for more details.
Publicidad
Tabla de contenido
