Ignition Switch - Simplicity Regent Serie Manual Del Operador

Headlights
The light switch turns the tractor headlights on and off.
Hour Meter
The hour meter measures the number of hours the key
has been in the RUN position.
Reverse Mowing Option (RMO)
The Reverse Mowing Option allows for mowing (or use of
other PTO driven attachments) while traveling in reverse.
If you choose to mow or operate another attachment in
reverse, turn the RMO key after the PTO is engaged. The
L.E.D. light will illuminate, and the operator can then mow
in reverse. Each time the PTO is disengaged the RMO
needs to be reactivated if desired.
PTO switch
The PTO (Power Take-Off) switch engages and disen-
gages attachments that use the PTO. To engage the PTO,
pull UP on the switch. Push DOWN to disengage. Note
that the operator must be seated firmly in the tractor seat
for the PTO to function.

Ignition switch

The ignition switch starts and stops the engine, it has three
positions:
OFF Stops the engine and shuts off the
electrical system.
RUN Allows the engine to run and powers the
electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN position
with the engine stopped–this drains the battery.
Ground speed Pedals
The tractor's forward ground speed is controlled by the
forward ground speed control pedal. The tractor's reverse
ground speed is controlled by the reverse ground speed
control pedal.
Depressing either pedal will increase ground speed. Note
that the further down the pedal is depressed, the faster the
tractor will travel.
cruise control
The cruise control is used to lock the ground speed control
in forward. The cruise control has five lock positions.
en
FEATURES AND CONTROLS
Mower Height of cut adjustment
The cutting height adjustment knob controls the mower
cutting height. The cutting height is infinitely adjustable
between 1.0" and 4.0" (2,5 and 10,2 cm).
attachment lift control lever
The mower deck lift lever raises and lowers the mower
deck and has two positions: Transport and free-float.
Set the lever to free-float for mowing. Set the lever to
transport when using the tractor for non-mowing applica-
tions or when transporting the tractor. DO NOT engage
the PTO with the mower in the raised transport position
or you may damage the belt.
seat adjustment lever
The seat can be adjusted forward and back. Move the
lever, position the seat as desired, and release the lever
to lock the seat into position.
Transmission Release lever
The transmission release lever deactivates the trans-
mission so that the tractor can be pushed by hand. See
Pushing the Tractor by Hand section.
fuel Tank
To remove the cap, turn counterclockwise.
fuel level Gauge
Displays the fuel level in the tank.
Parking Brake
The parking brake knob is used to lock the parking brake
when the tractor is stopped. Fully depressing the brake
pedal and pulling up on the knob engages the parking
brake.
Brake Pedal
Depressing the brake pedal applies the tractor brake.
13