Specifications; Parts And Accessories - Simplicity Regent Serie Manual Del Operador

ENGINE
19.5 HP Briggs & Stratton
Model Professional Series™
Horsepower 19.5 HP @ 3500 +/- 100 rpm
Displacement 30.42 cu in. (500 cc)
Electrical System Alternator: 15A Reg.
Battery: 12 Volt, 195 CCA
Oil Capacity 48 oz (1,4 L)
CHASSIS
Fuel Tank Capacity Capacity: 4.0 gal (15,1 L)
Front Wheels Tire Size: 15 x 6,0-6
Inflation Pressure: 12-14 psi (0,82-0,96 bar)
Rear Wheels Tire Size: 20 x 8,0-8
Inflation Pressure: 10 psi (0,68 bar)
Power Rating
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive
Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and
corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values
are derived at 3600 RPM. Net power values are taken with exhaust and air cleaner installed whereas gross power values
are collected without these attachments. Actual gross engine power will be higher than net engine power and is affected
by, among other things, ambient operating conditions and engine-to-engine variability. Given the wide array of products
on which engines are placed, the gas engine may not develop the rated gross power when used in a given piece of power
equipment. This difference is due to a variety of factors including, but not limited to, the variety of engine components
(air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions
(temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs &
Stratton may substitute an engine of higher rated power for this Series engine.
See an authorized dealer.
TRANSMISSION
K46Z
Type Hydrostatic Tuff Torq K46Z
Engine Oil 10w 30 Premium Engine Oil
Speeds Forward: 0-5.5 MPH (0-9,0 km/h)
@ 3400 rpm Reverse: 0-3.0 MPH (0-4,6 km/h)
170 ft-lbs (230,5 Nm)
Continuous Torque
Output
MOWER
Width of Cut 38" (96,5 cm)
Number of Blades 2
Base Deck Platform Side Discharge
Cutting Height 1.0-4.0 in. (2,5-10,2 cm)
Cutting Positions Infinite

SPECIFICATIONS

PARTS AND ACCESSORIES

23