Bellelli TIZIANO Manual Del Usuario página 13

Comfort
Do not pull the harness too tightly on the child's
body.
When the child seat is used on the rear seats
of the car, make sure there is enough room for
the child's feet. If necessary, move the front seat
forward slightly.
Take frequent breaks on long journeys so the
child can move about freely.
Components of the child seat
Identify the components of the child seat before
using it. Carefully study figure 1.
A. Inclination adjustment handle
B. Isofix system depth adjustment button
C. Support leg
D. Support leg rest indicator
E. Support foot
F. Support leg length adjustment button
G. Adjustment strap
H. Adjustment button
I. Buckle padding
J. Buckle
K. Safety harness padding
L. Safety harness
M. Cover
N. Child seat
O. Seat protectors
P. Safety belt lock
Q. Isofix connector
R. Isofix connector release lever
S. Base
T. T-shaped metal clip
U. Metal padding clip
Preliminary adjustment of the child seat
Adjust the height of the safety harness (L) before
fitting the child seat in the vehicle.
Adjusting the height of the safety harness
Put the child seat on the floor.
Place the child in the seat.
Check that the harness straps are in the position
closest to the child's shoulders and preferably
in the position just above the child's shoulders
(see fig. 2).
How to move the child seat's safety harness
Press the adjustment button (H) and simultaneously
pull both safety harness straps (fig. 3).
Release one safety harness strap from the
T-shaped metal clip (T) positioned behind the
backrest of the child seat (fig. 4).
Pull out the harness strap from the backrest.
Pull out the metal clip (U) from the backrest (fig. 5).
Insert the metal clip (U) and the harness strap
(L) at the required height (fig. 6 and 7).
Re-attach the harness strap to the T-shaped
metal clip (fig. 8).
Repeat the procedure with the other strap.
Warning: ensure that the straps pass through
the padding (K) and that the rubber side is facing
the body of the child.
Warning: ensure that the straps are not twisted.
Warning: ensure that the metal clips (U) holding
the padding in place cannot come loose from
the backrest.
How to recline the child seat
Pull the inclination adjustment handle (A) and
simultaneously move the seat forwards or
backwards to the required inclination (fig. 9).
Warning: once you have released the handle,
always check that the child seat is locked in the
chosen position.
Fitting the child seat
The child seat can be used in two ways:
• with Isofix and the support leg;
• with the vehicle's safety belts and the
support leg.
Warning: do not carry out the installation and
fitting procedures with the child in the seat.
Warning: never use the Isofix and safety belt
installation systems at the same time.
Position the child seat on the front passenger
seat or on one of the rear seats.
Warning: the child seat must be facing the
direction in which the vehicle travels.
Warning: in some countries the Highway Code
prohibits the fitting of child seats on the front
seats of vehicles. Check the Highway Code of
the country you are in.
Warning: do not place the child seat on the front
seat of the vehicle if there is an active airbag.
Warning: do not insert anything between the
child seat and the vehicle seat.
Warning: do not put the child seat on swivel
seats or seats facing the opposite direction to
that in which the vehicle travels.
11
EN