Get Started; Treatment Steps - Silk’n Infinity H3102 Manual Del Usario

8. Get started!

8.1 Connect the device
1. Remove the device and other components from the box.
Place the adapter cord into the device and connect to the
2.
electricity supply. All the energy level indicator lights will go
on and off repeatedly in a circular motion.
8.2 Do a spot test
It's important to do a spot test on each part of the body you wish to
treat. A spot test checks that the skin color is suitable for treatment,
and that you know which energy level is comfortable for the area you
are treating. Both skin color and energy level may vary depending on
the target treatment area.
1. To do a spot test, follow steps 1-5 and 7-9 in the next section.
2. If you experience little or no discomfort during and after use
at the lowest energy setting, increase the energy level by one
indicator light the next time you use the device, and so on for
each subsequent hair removal session.
3. Repeat the spot test for each area you wish to treat.

8.3 Treatment steps

1. Remove all jewelry before use.
2. Before treatment, the skin should be shaved, clean, dry and free
of any powders, antiperspirants or deodorants. Do not wax,
pluck or tweeze the hair out.
3. Be sure to cover up tatoos, moles, warts, large freckles, black
spots or other marks on the skin that should not be treated. Use
a material that does not absorb the light such as a white cloth
or white medical tape.
Press the control button. The device will turn on, the level 1
4.
energy level indicator light will be on, and a fan sound will
start.
21
EN