Information On Safety - afriso PrimoSol 130-1 Manual De Instrucciones

2.2 Intended use
This product may only be used to circulate the following liquids in intrinsically
safe, sealed, solar systems:
• Standard heat transfer fluids (solar liquids) suitable for solar systems such
as water-glycol mixtures
The integrated safety group assembly serves to secure against excessive
pressure.
Any use other than the application explicitly permitted in these operating
instructions is not permitted and causes hazards.
Verify that the product is suitable for the application planned by you prior to
using the product. In doing so, take into account at least the following:
• All directives, standards and safety regulations applicable at the installa-
tion site of the product
• All conditions and data specified for the product
• The conditions of the planned application
In addition, perform a risk assessment in view of the planned application,
according to an approved risk assessment method, and implement the
appropriate safety measures, based on the results of the risk assessment.
Take into account the consequences of installing or integrating the product
into a system or a plant.
When using the product, perform all work and all other activities in conjunc-
tion with the product in compliance with the conditions specified in the oper-
ating instructions and on the nameplate, as well as with all directives, stand-
ards and safety regulations applicable at the installation site of the product.
2.3 Predictable incorrect application
The product must never be used in the following cases and for the following
purposes:
• Operation with swimming pool water
• Use with adherent, corrosive or flammable fluids
• Temperatures and pressures in excess of or below the permissible tem-
peratures and pressures
2.4 Qualification of personnel
Only appropriately trained persons who are familiar with and understand the
contents of these operating instructions and all other pertinent product doc-
umentation are authorized to work on and with this product.

Information on safety

PrimoSol® 130
EN
4