Tabla de contenido
Publicidad
O p e r a t i n g In s t r u c t i o n s
Re a d t h e ENT IRE IM PO RT ANT S AF ET Y INF O RM AT IO N s e c t i o n a t t h e b e g i n n i n g o f t h i s
m a n u a l i n c l u d i n g a l l t e x t u n d e r s u b h e a d i n g s t h e r e i n b e f o r e s e t u p o r u s e o f t h i s p r o d u c t .
Co m p r e s s o r Ar e a S e t Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by
children or pets to prevent injury.
2. Locate the Compressor on a flat level surface to
ensure proper pump lubrication and to prevent
damage to the unit. Keep at least 12" of space
around the unit to allow air circulation.
G e n e r a l O p e r a t i o n
1. Turn red regulator knob counterclockwise completely.
2. Close the Drain Valve.
3. Plug the Air Compressor Power Cord into
a grounded 120 VAC electrical outlet.
4. Turn the Switch ON.
5. Allow the Air Compressor to build
up pressure until it cycles off.
No t e : At the beginning of the day's first use of the
Air Compressor, check for air leaks by applying soapy
water to connections while the Air Compressor is
pumping and after pressure cut-out. Look for air bubbles.
If air bubbles are present at connections, tighten
connections. Do not use the Air Compressor
unless all connections are air tight, the extra air
leaking out will cause the compressor to operate
too often, increasing wear on the compressor.
Page 10
F o r t e c h n i c a l q u e s t i o n s , p l e a s e c a l l 1 - 8 8 8 - 8 6 6 - 5 7 9 7 .
3. Route the power cord from the compressor
to the grounded wall outlet, along a safe path
without creating a tripping hazard or exposing
the power cord to possible damage.
No t e : As long as the Power Switch is ON, the operation
of the Air Compressor is automatic, controlled by an
internal pressure switch. The Compressor will turn on
automatically when the air pressure drops to 85 PSI,
and will turn off automatically when the
air pressure reaches 100 PSI.
W ARNING ! T O
INJ URY AND D EAT H F RO M
D o n o t a d j u s t t h e i n t e r n a l
p r e s s u r e s w i t c h . Any change to the
automatic pressure levels may cause
excess pressure to accumulate,
causing a hazardous situation.
6. AF T ER the Compressor builds up enough
pressure and shuts off, adjust the Air Compressor's
Regulator Knob so that the air output is enough
to properly power the tool, but the output will
not exceed the tool's maximum air pressure at
any time. Turn the knob clockwise to increase
the pressure and counter-clockwise to decrease
pressure. Adjust the pressure gradually, while
checking the air output gauge to set the pressure.
PREV ENT S ERIO US
EX PL O S IO N:
Item 60637
Publicidad
Tabla de contenido
