Electrical Connections - Craftmade Toscona TO52 Instrucciones De Instalación

14
Operation Instructions
1. The sequence of operation for the motor pull/chain switch is
OFF-HI-MED-LOW.
2. Push the slide switch RIGHT for FORWARD, and LEFT for
REVERSE action of the blades.
3. The pull chain switch for the lighting is two positions - ON/OFF.
Light Pull Chain
CAUTION
Even if your fan is mounted with the blades more than 7 feet from the floor, be
careful to avoid placing your raised arms or any object in the path of the blades.
15

Electrical Connections

Connect black and blue (if provided) fan wires to black outlet wire.
Connect white fan wire to white outlet wire and green grounding lead
wire from the grounding conductor to the supply circuit (see figure A).
Use wire connectors provided with your fan. No loose strands or loose
connections should be present. After wires have been connected, they
must be spread apart so the green and white are on one side of the outlet
box and the black and blue are on the other side. Turn
splices upward and carefully
push all wiring into outlet
box. For optional wall
Black
control see figure B or
Figure C for alternate wiring.
When wall switches are employed,
switches should be UL listed
for use with ceiling fan.
NOTE: Make sure fan on/off switch
is always at "high speed" location if
your fan is controlled by additional
wall switch.
Motor Pull Chain
Slide Switch
Ground
White
Blue
Black
Figure A
Optional Light
15
White
Black
Light Switch
White
Black
Fan
Switch
Light
Switch
Green
White
Electrical Connections Continued...
Ground
Black
Blue
Figure B
Ground
Black
Black
Blue
Figure C
Green
White
Optional Light
Green
White
Optional
Light