Replacing The Blade - Grouw 50799 Manual De Instrucciones

Switch on the motor using the on/off switch
and allow the blade to reach full speed.
Grasp the cradle handle and push the cradle
towards the blade in a smooth gliding
motion.
When the item nears the blade, the blade
guard is pushed to the side and the blade
saws through the wood. Pull the cradle back
once sawing is complete. The blade guard
closes automatically and you can guide the
workpiece forward in the cradle to prepare
the next cut.
If the wood has not been fully sawn through,
you must turn it 180 degrees and saw it
through again.
Switch the saw off using the on/off button
once sawing is complete.

Replacing the blade

Step 1
Remove the right outer screen.
Step 2
Remove the screws, washers and spring
washers on the top of the inner screen.
Step 3
Remove the hexagonal screens on the right
inner screen.
GB
59