Greenlee GATOR LS50L2 Manual Operación página 10

Setup and Operation (cont'd)
Note: Refer to "Capacity and Draw Stud Selection Guide" on page 13
for capacity, draw stud, and hardware.
Punching mild steel with
3-1/2" (ø 4.044" [102.7 mm])
to 4" (ø 6.375" [161.9 mm])
conduit sizes
Punching
stainless steel with
1/2" (ø 0.885" [22.5 mm])
conduit size
Punching
stainless steel with
3/4" (ø 1.115" [28.3 mm])
to 2" (ø 2.416" [61.5 mm])
conduit sizes
Greenlee / A Textron Company
Material
Being
Punched
ø 1-3/8" (34.6 mm)
Pilot Hole
1557AA
Sleeve
Punch
Material
Being Punched
1/2" (12.7 mm)
Pilot Hole
Punch
Material
Being Punched
7/8" (22.2 mm)
Pilot Hole
Punch
LS50L2 Battery-powered Punch Driver
2113B
Draw Stud
Die
29451
Draw Stud
Die
29452
Draw Stud
Die
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070