Instruction For The Installer - Unox XC 111 Manual De Instrucciones

ENGLISH
I. INSTRUCTION FOR
THE INSTALLER
Dear customer, we would like to thank you
and congratulate you on the purchase of one
of UNOX products. The instructions and sug-
gestions that follow concern the phases of a
proper installation, as well as the use and
maintenance for your safety and for the best
use of the appliance.
1. CERTIFICATION
The appliance has the CE mark.
2. INSTALLATION
- PRELIMINARY OPERATIONS
All the electrical connections and installations
must be done by qualified personnel accor-
ding to actual laws.
2.1 Check the installation location
Before placing the appliance, please verify the
overall measurements and the exact position
of the electrical connections looking at the pic-
tures on the attached file "TECHNICAL DATA".
2.2 Positioning
The steam condenser has to be placed upon
the oven and must be connected to the fume
exhaust chimney (see the picture).
3. INSTALLATION
3.1 – ELECTRICAL CONNECTION
3.2 – WATER CONNECTION
3.1 Electrical connection
a-The connection to the electrical power
supply system must be done according to
the standard in force.
Before connecting the appliance, make
yourself sure that the voltage and the fre-
quency correspond to those stated on the
data plate of the appliance. The appliance
must be placed so that the connection plug
to the network can be easily reached.
Place an omni-polar switch between the
appliance and the network so that it is easily
accessible. The contacts of this switch must
have a minimum opening distance of 3 mm
and the switch must have an appropriate
input (for example, magneto-thermal
switch).
When the appliance is working the power
supply voltage must not diverge from the
value of the nominal voltage, written on the
technical data plate, by more than ± 10%.
b- The appliance must be connected to the
round line of the network.
Moreover, the appliance must be included
in an equipotential system whose efficiency
must be properly checked according to the
current law. This connection must be done
between the different appliances using the
terminal marked with the symbol:
The equipotential conductor must have a
minimum section of 10 mm2.
STEAM condenser connection
To connect steam condenser to the oven,
please operate as follows:
1- Remove the back of the oven;
UNO X
R
ENGLISH 2