Cleaning The Espresso Machine; In Case Of Malfunctioning; Improper Use Of The Appliance; Installation And Start-Up Of Espresso Machine - illy Francis Francis Y1 Manual De Instrucciones

Cleaning the espresso machine

- Unplug the machine before cleaning.
- Before unplugging the machine check that the main on/
off switch "M" is in the "0" position.
- Wait until the machine is cool before cleaning.
- Clean the body and attachments with a wet cloth and
then wipe with a non-abrasive dry cloth. Do not use de-
tergents.
- Do not expose the machine to extended jets of water or
immerse it in water, partially or fully.

In case of malfunctioning

Do not use the appliance if the cord or plug are damaged or if
the appliance shows signs of malfunctioning or has been da-
maged in any way. Take the machine to the nearest authorized
service center for checks or repairs.
If the power cord is damaged it must be replaced by the manu-
facturer or an authorised service center.
In case of damage or malfunction, turn off the appliance and
do not tamper with it. For repairs contact a service center au-
thorised by the manufacturer and request the use of original
spare parts only. Failure to comply with these instructions may
compromise the safe operation of the machine and will result
in the forfeiture of warranty rights.

Improper use of the appliance

- This appliance is intended for household use only. Any
other use is to be regarded as improper and thus dange-
rous.
- The manufacturer is not liable for accidents caused by
non-compliance with existing legislation on electrical
grounding systems.
- The manufacturer is not liable for possible damage cau-
sed by improper, incorrect or unreasonable use.
This appliance is intended to be used in household and similar
applications such as:
- staff kitchen areas in shops, offi ces and other working
environments;
- farm houses;
- by client in hotels, motels and other residential type envi-
ronments;
- bed and breakfast type environments.
15
INSTALLATION AND START-UP
OF ESPRESSO MACHINE
Before connecting the machine to a power supply, carefully
read the safety instructions given in the chapter: "important
safeguards".
Remove the water tank "L" from the machine by pulling it
slightly up and then out.
Lift the tank lid.
Fill the tank with fresh drinking water until the MAX mark is
reached.
CAUTION: always fi ll the tank with fresh, still drinking wa-
ter only. Hot water or other liquids may damage the tank.
Do not use the machine without water.
After setting the lid back in place, insert the tank completely
into the machine until it clicks fi rmly into place.
EN