Safety Instructions For Cleaning And Care; Safety Instructions Regarding Fault Repair; Notes On Specific Hazards - Hupfer Powerstapler PSUH Manual De Instrucciones

Safety Instructions

Safety Instructions for Cleaning and Care

2.4 Safety Instructions for Cleaning and Care
The following aspects must be taken into account when performing any cleaning and care tasks:
§
Cleaning instructions must be strictly observed for reasons of hygiene.
§
Take the appliance out of operation before starting the cleaning process. Pull out the mains plug and
place it into the holder located on the appliance.
§
For cleaning, the appliance must be out of operation and cooled down sufficiently.
§
Do not clean the appliance with steam-jet or high-pressure cleaners. The appliance must be taken out
of operation and switched off at the mains beforehand in any area where high-pressure steam or
pressure washers are to be used.
§
Even appliances without an electrical connection should not be cleaned with running water or pres-
surised water.
2.5

Safety Instructions Regarding Fault Repair

The following points shall be observed when carrying out any maintenance or fault repairs:
§
Any fault repairs may be carried out by authorised specialists only.
§
Ensure that the appliance is switched off when carrying out repairs. The appliance must be switched
off at the mains and secured against reactivation when working on the electrical system.
§
For troubleshooting, the appliance must be out of operation and cooled down sufficiently.
§
The local Accident Prevention Regulations in force must be observed.
§
Only use original spare parts to replace defective components.
2.6

Notes on Specific Hazards

Electric power
§
All work on the electrical installations may only be carried out by a qualified electrician or by author-
ised specialists under the supervision and monitoring of a qualified electrician according to the appli-
cable electro-technical regulations.
§
The appliances on which inspection, maintenance and fault repairs are performed must be discon-
nected from the power supply and secured against reactivation when power is not required for such
work. This may only be carried out by a qualified electrician.
91346811_A1
Section 2
Page 11
Powerstapler
PSUH