Axkid Wolmax Manual Del Usuario página 6

Allowed and disallowed positioning of the child car seat.
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Forward facing seat with 3-point seat belt
Seat with 2-point seat belt
Side facing seats
Rear facing seats
Never use this child seat in a car that is not equipped with an
ECE Reg 16 approved three-point belt.
Rear-Facing 9-25 Kg With Seat Belt & Tethers
Adjusting The Headrest And Harness Height
Before you install the child restraint make sure that the headrest is at the correct height for your
2
child. The harness, when correctly installed, should be routed from the back of the seat to the
front and pass just above your child' s shoulders.
In order to adjust the height of the headrest and harness you will first need to detach the
3
harness. Press the harness adjuster button (E) and pull forward on the shoulder straps (not the
shoulder pads) to completely loosen the harness.
4
Open the zipper (N) on the back of the seat cover.
Unhook the shoulder straps from the yoke (R) at the back of the child restraint and pull the two
5
shoulder straps through to the front of the seat.
Detach the shoulder pads (B) on the back of the seat and pull the two shoulder pad straps
6
through to the front of the seat.
7 Squeeze the plastic clip and gently pull the headrest free from the seat.
Reposition the headrest at one of the three heights that best suits your child. Push the bottom
8
of the headrest until the plastic clip locks in place.
Thread the shoulder pad straps out through the holes in the headrest to the back of the seat
9
and reconnect the two shoulder pad straps.
WARNING! Never use this child seat without the shoulder pads. The shoulder pads are an
important safety feature.
5
Yes
NO
Yes
NO
NO
NO