MAINTENANCE AND REPAIR INSTRUCTIONS
7. Before you reinstall the clevis pins and pin clips,
ensure that the tips on the tines are staggered when
compared to each other (Fig. 7).
8. Repeat this procedure on the opposite side.
NOTE: When installed correctly, there will be an "R" and
"L" tine on both the sides of the gearbox and the
tips of the tines. These letters will line up in the
same direction for each side. It is important that
the tines are installed correctly.
Felt
Washer
Shaft
L
CULTIVATOR ADD-ON
Operating Weight of Attachment: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 lbs. (4.65 kg)
Adjustable Tine Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6" to 10.25"
Steel Tines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8"
Stagger Tips
L
R
Fig. 7
SPECIFICATIONS
STORAGE
• Check unit before storage to be sure the equipment is
in safe working condition.
• Stop the engine or motor.
• Store the unit indoors, in a dry and locked place, out of
the reach of children.
For gas powerhead units
• Allow the unit to cool before storing in any enclosure.
• Drain fuel from unit. Never store the unit with fuel in the
fuel tank inside a building where ignition sources are
present such as hot water and space heaters, clothes
dryers, etc.
TRANSPORTING
• Allow the unit to cool before transporting.
• Secure the unit while transporting.
For gas powerhead units
• Drain fuel from unit.
• Tighten fuel cap before transporting.
ACCESSORIES/REPLACEMENT PARTS
Tine Assembly (Left Outer and Right Inner) . . . . .182729
R
Tine Assembly (Left Inner and Right Outer) . . . . .182730
Tine Fastener Assembly . . . . . . . . . . . . . . . . . . . .147473
Use only original equipment replacement parts.
9