Important Safety Precautions; Spare Part - Facom 848C.100 Guía De Instrucciones

Important Safety Precautions

1. CAUTION:The tool reaches high temperature! May cause burn.
2. Keep out of reach of children. This is not a toy and not intended for use by children.
3. Misuse may cause burns, electric shock and injuries.
4. Do not immerse tool in water or other liquid! Danger of electric shock!
5. Always use the tool on a heatproof and uncluttered table.
6. After finished using the tool, let the tool cool naturally before storing away.
7. If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
8. This appliance can be used by children from 8 years and above and persons with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, if they have been given supervision or instruction concerning use of
the appliance in safe way and understand the hazards involved.
9. Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
10. For domestic use only. Use only for the intended purposes.
Operating Instructions
1. Check that the voltage on the soldering tool is same as source of current.
2. Make sure the tip is in fixed position and screw is tightened.
3. Connect soldering tool to mains current.
4. Surfaces of the connection points must be clean.
5. "Tin" the tip by covering the heated tip with rosin core solder.
6. Use the soldering tool to heat the connection points, not the solder.
7. Apply only enough solder to the heated parts.
8. Allow the joint to cool undisturbed.
9. Clean the tip with a wet sponge while the tip is still heated.
10. After use, unplug the tool and let the tool cool down naturally on the stand, out of reach of
children.
11. To prolong the life of the soldering gun and tip, it is recommended that you limit the
switch-on position to a maximum of 12 seconds, and allow a break for minimum 48 seconds
before the next "on" position, i.e. only heat when actually soldering.

Spare part

High Power - Set of 2 soldering tips : 848.100P5
NU-848C.100_1016.indd 4
READ ALL INSTRUCTIONS BEFORE USE
SAVE THESE INSTRUCTIONS
4
EN
25/10/2016 08:26:39