Razor E300 Manual Del Propietário página 9

REPAIR AND MAINTENANCE
q Adjusting the Chain
Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches.
1
Using two 17mm wrench-
es, loosen the rear axle bolts
by turning the wrenches
counter clockwise.
4
Once the tension is
correct, tighten the axle bolts
and brake housing anchor
bolt. Test ride the scooter.
Readjust as needed.
q Battery Care and Disposal
Do not store the battery in temperatures above 75° or below -10° F.
CONTAINS SEALED NON-SPILLABLE LEAD BATTERIES. BATTERIES MUST BE RECYCLED.
Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in
an environmentally sound manner. Do not dispose of a lead-acid battery in a fire. The battery may explode
or leak. Do not dispose of a lead-acid battery in your regular household trash. The incineration, land filling
or mixing of sealed lead-acid batteries with household trash is prohibited by law in most areas. Return
exhausted batteries to a federal or state approved lead-acid battery recycler or a local seller of automotive
batteries. If you live in Florida or Minnesota, it is prohibited by law to throw away lead-acid batteries in the
municipal waste stream.
q Charger
The charger supplied with the scooter should be regularly examined for damage to the cord, plug, enclosure
and other parts, and, in the event of such damage, the scooter must not be charged until it has been repaired
or replaced.
Use ONLY with the recommended charger.
q Replacement Parts
For a complete selection of parts, visit www.razor.com.
q Repair Centers
For a list of authorized Razor repair centers:
• Check online at www.razor.com.
• Call 866-467-2967 for the center nearest you.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at
www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00AM - 5:00PM Pacific Time.
2
Using two 8mm wrenches,
loosen the brake housing
anchor bolt which is located
in the long slot on the left
side of the rear fork.
3
Using a 10mm wrench,
tighten the tension adjust-
ers on the axle 1/8 to 1/4
turn to fine-tune the chain
tension. Both adjusters must
be tightened the exact same
amount to maintain wheel
alignment.
8
Note: This system of adjusters
is common to motorcycles
and BMX bicycles. If you are
not familiar with it or do not
feel comfortable performing
the adjustment, consult an
authorized Razor service center
or a qualified BMX bike or
motorcycle mechanic.
The chain should be "just taut"
– in other words snug, but not
piano-wire tight. The tension
should be similar to the fan
chain on an automobile. BE
CAREFUL NOT TO ADJUST TOO
TIGHT. The tensioning system
can easily impart too much
tension and snap the chain or
bend the motor shaft. Adjust
1/8 to 1/4 turn at a time and
check the tension each time.
WARNING: If a
battery leak develops, avoid
contact with the leaking acid
and place the damaged battery
in a plastic bag. Refer to the
disposal instructions at left. If
acid comes into contact with
skin or eyes, flush with cool
water for at least 15 minutes
and contact a physician.