Troubleshooting Chart - Alemite 7373 Guía De Servicio

Double Post Fuel Hose Reel
Indications
Reel does not latch Pawl Spring (36) broken or not attached to Pawl (38)
Reel does not retract Power spring broken*
Reel retracts partially 1. Improper power spring tension
2. Hose length greater than 30 ' (9.1 m)
Reel does not unlatch 1. Power spring wound solid
after maximum length 2. Hose removed from the reel too quickly
of hose is removed (Reel Over-Run)
Material leakage at 1. Connection not sufficiently tight and / or thread
Swivel Assembly sealant missing at 90 ° Union (1) or Pipe Plug (4)
2. Worn or damaged Quad-Rings (7)
3. Worn or damaged Swivel Body (5)
* The possible causes for broken components are listed in italics
Alemite, LLC
1-800-548-1191-http://www.partdeal.com-info@partdeal.com

Troubleshooting Chart

Possible Problems
Changes Since Last Printing
Added Ratchet Guard & updated repair parts
7
Solution
Replace or secure Pawl Spring (36)
Replace Power Spring Assembly (16)
1. Adjust tension
2. Install a hose not to exceed 30 ' (9.1 m)
1. Decrease power spring pre-wind
2. Remove hose slowly when close to being fully
extended
1. Apply sealant to male threads of 90 ° Union (1)
or Pipe Plug (4) and tighten connections
2. Use Repair Kit 393701
3. Replace Swivel Body (5)
SER 7373
Revision (6-11)