Button Functions - APLIC 302145/20170111SZ137 Manual De Usuario

1 Battery charging bays
2 Selection buttons
3 Display (1 for each charging bay)
4 "Mode" button
5 "Display" button
6 "Current" button

4.1 Button functions

Selection With this button, you can select the desired charging bay to
buttons configure the mode or the charging current.
"Mode" button Using the "mode" button, you can select between the
two modes of "Charging" and "Test". To configure all the
charging bays at the same time, press and hold the button
for about 4 seconds till the display starts to flash. You can
configure the charging current using the "current" button.
If you want to individually configure the charging bays, then
you need to select the desired charging bay (1-4) before-
hand using the selection button.
"Display" By pressing the "Display" button, you can select the informa-
button tion about current, voltage, capacity, internal resistance and
the previous charging time, on the respective display.
"Current" The charging and discharging current can be configured
button using this button. This button has only one function if you
select one charging bay using one of the selection buttons,
or all the charging bays by pressing the "Mode" button for
4 seconds.
English
13