Important Safety Information - Samson MXS Serie El Manual Del Propietario

Important Safety Information

1. Read these instructions.
2. Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
This apparatus shall not be exposed to dripping or splashing liquid and no object
filled with liquid, such as a vase, should be placed on the apparatus.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance with the
manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatuses (including amplifiers) that produce heat.
9. Only use attachments/accessories specified by the manufacturer.
10. Unplug this apparatus during lightning storms or when not in use for long periods of
time.
11. Do not override the intended purpose of the polarized or grounding-type plug. A
polarized plug has two blades, with one wider than the other. A grounding-type
plug has two blades and a third grounding prong. The wide blade, or third prong,
is provided for your safety. If the provided plug does not fit your outlet, consult an
electrician to replace the obsolete outlet.
12. Protect the power cord from being walked on or pinched, particularly at the prongs,
convenience receptacles, the point where they exit from the apparatus.
13. Use only with the cart stand, tripod bracket, or table specified by
the manufacture, or sold with the apparatus. When a cart is used,
utilize caution when moving the cart/apparatus combination to
avoid injury from tip-over.
14. Refer all servicing to qualified service personnel. Servicing is
required if the apparatus has been damaged in any way, such as
power-supply cord or plug breakage, damage due to liquid or objects falling onto
the apparatus, exposure to rain or moisture, or if the apparatus does not operate
normally, or has been dropped.
15. MAINS DISCONNECT: The plug should remain readily operable. For rack-mount or
installation where plug is not accessible, an all-pole mains switch with a contact
separation of at least 3 mm in each pole shall be incorporated into the electrical
installation of the rack or building.
16. FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE:
Replace fuse with same type and rating only.
17. MULTIPLE-INPUT VOLTAGE: This equipment may require the use of a different
line cord, attachment plug, or both, depending on the available power source at
installation. Connect this equipment only to the power source indicated on the
equipment rear panel. To reduce the risk of fire or electric shock, refer servicing to
qualified service personnel or equivalent.
MXS Series Power Amplifiers
3