swissflex Box 75RF Modo De Empleo página 22

do not disassemble or modify
them, do not allow children to
play with them and prevent frail
individuals from using the prod-
uct without supervision.
The product may not be used
with a medical device or be in-
stalled in a medical device.
The product may not be used in
an environment in which flam-
mable or explosive gases or va-
pours (e.g. anaesthetics) are
likely to occur.
The product may not be used to
raise and lower loads.
Only use spare parts that have
been produced or approved by
Swissflex . Only these parts
®
guarantee adequate safety.
The Swissflex
only be used with the power sup-
ply provided.
22
Operating instructions
Box _75RF may
®
Initial setup «Touch»
Place the batteries into the radio remote control
Remove the cover from the battery compartment
(17) on the back of the radio remote control. Place 3
AAA-batteries (18) into the compartment, paying at-
tention to the +/- markings. Close the compartment
cover again. The maximum range of the radio remote
control is 15 metres.
Teaching-in the radio remote control (already
taught-in in the factory)
1. Remove the radio remote control's battery cover on
the back of the device.
2. Insert / check the batteries (3 x AAA).
3. Activate the teach-in button (26) on the switching
power supply (press 2 x).
4. A small red button is located above the batteries in
the battery compartment (17).
5. Press the button; a blue LED will start flashing.
6. Hold the button down until the blue LED is
permanently illuminated; this means that pairing
has been completed.
Bluetooth
®
1. Download the standard „Swissflex
relevant platform for Android (Google play) or Apple
iOs (App Store).
2. Install the standard „Swissflex
Smartphone / Tablet PC.
3. Installation / Initial setup, see manual of the Blue-
tooth RF-Gateway.
Synchro function (with sync cable)
When two Swissflex
®
with a sync cable (connection jack (19)), the synchro
function (13) is required. By pressing and holding down
the button (13), the synchro function is activated/de-
activated. When pressing the travel button (6-7), the
control systems synchronise and then move in the con-
firmed direction of travel. After successful activation,
the button glows blue continuously. After successful
deactivation, the button appears white. After plugging
in the sync cable, carry out a reset as follows:
• Press down the 'Memory/Save' button (14) for 3 se-
conds.
• The M1-M4 buttons will first light up blue and then
switch to white again.
• The LCD backlighting system will flash white once
after several seconds.
• Immediately press down the synchro button (13)
and keep it pressed down. The control systems po-
wer down.
• If the entire backlighting system flashes white twice,
you can release the synchro button (13).
The internal meter readings for the individual motors
" app from the
®
" app onto your
®
Box _75RF are linked together
EN