Snapper SXDWM82 El Manual Del Propietario página 18

ASSEMBLY INSTRUCTIONS
TO INSTALL BATTERY PACK (See Figure 7)
• Lift and hold up the battery door (1).
• Align the battery (2) with the mower's battery port.
• Make sure the battery release button (3) snaps in place and that battery is fully seated and
secure in the mower before beginning operation.
• If the machine is not going to be used immediately, remove the battery.
• Close the door.
TO REMOVE BATTERY PACK (See Figure 7)
• Release the bail lever to stop the mower.
• Open the battery door.
• Press the battery release button (3) on the mower. This will cause the battery to raise out of
the tool slightly.
• Remove battery from the mower.
(3) Battery
release button
(1) Battery door
(2) Battery pack
18
Fig. 7