George Foreman GP200 Manual De Uso Y Cuidado página 12

8) If "growing" bubbles appear on any of the connection points, then you have
detected a gas leak. Immediately turn the regulator control knob to the OFF/Lock
position and disconnect the LP cylinder from the regulator.
A) If a leak appears at the cylinder/regulator connection, unscrew the cylinder
and retighten, but do not over tighten. (Note: Only hand tighten. Do not use any
tools) Repeat Leak Test.
B) If a leak can not be stopped, disconnect the LP cylinder and do not use the grill.
Call Customer Service at 1-800-231-9786.
STEP 2. If no leaks are found, the grill is ready to be operated.
OPERATING YOUR LP GAS GRILL
WARNING!
• Before proceeding, make certain you understand the IMPORTANT
SAFEGUARDS at the beginning of this manual.
• Before lighting the LP gas grill, you must open the lid to prevent an explosion from
gas build-up.
• If your LP gas grill catches on fire:
- If the fire is in the grill portion and you can safely reach the regulator knob, then
turn it to the Off position.
- If the fire involves the cylinder or tube, leave it alone, evacuate the area and
call the fire department.
- If there is any type of fire that threatens either personal safety or endangers
property, call the fire department.
• Do not operate an LP gas grill if you have knowledge of or suspect a gas leak.
• Never allow children to operate or play near an LP gas grill. Do not leave grill
unattended.
• Always turn off the LP gas cylinder when not in use.
• Allow grill to cool before handling parts or cleaning.
• Do not move an LP gas grill when in use or hot.
• Never touch hot surfaces. Use heat resistant gloves, long-handled tongs,
or cooking mitts at all times since the grill will become very hot. Do not attempt
to close the Lid when cooking to avoid serious burns.
• Do not wear loose clothing (example: hanging shirt tails, clothing with frills, etc.)
around a LP gas grill while in use or hot.
• Never lean your body over the LP gas grill when lighting it or while it is in use or hot.
• Always empty grease cup before it fills up to prevent any grease fires.
12
Leak test at
regulator/
gas cylinder
connection
Fig. 13