Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING THE HEAD KIT (CONT.)
RE-ASSEMBLY (cont.)
Step 4: Assemble the cover and the spring in advance.
Use tip-end handle to put the spring in groove and press it.
Assembling finished. See Fig. 7
BEFORE USING THE WRENCH
BATTERY INSTALLATION
• Remove the battery cap.
• Insert one AAA batteries (provided) matching the -/+ polarities
of the battery to the battery compartment.
• Replace the battery cap and fasten it tightly according to the
illustrations.
SET UP
1. Power On/Clear
2.
Unit/Setting
3.
Memory (Stores up to 9 values)
4. Up/Down
SLEEP MODE
• The wrench will automatically go into "Sleep" mode after
being idle for 5 minutes to save power.
Press
to wake from "Sleep" mode.
RESETTING THE WRENCH
• If the wrench does not function normally,
DTW14FL
Fig. 7
2
3
4
1
Press
7
at the same time to reset the wrench.
+
-
Rev. 12/11/14
Publicidad
Tabla de contenido
