Ansel 2716 Guía De Usuario página 110

RTS Threshold: Packets over the specified size will use the RTS/CTS mechanism to
maintain performance in noisy networks and preventing hidden nodes from degrading the
performance. Specify a value between 0 and 2347. The default value is 2347.
ACK Timeout: The wait time for an ACK signal to time out.
Beacon Interval: Beacons are packets sent by a wireless Access Point to synchronize
wireless devices. Specify a Beacon Interval value between 25 and 1000. The default value
is set to 100 milliseconds.
DTIM Period: A DTIM is a countdown informing clients of the next window for listening to
broadcast and multicast messages. When the wireless Access Point has buffered
broadcast or multicast messages for associated clients, it sends the next DTIM with a DTIM
Period value. Wireless clients detect the beacons and awaken to receive the broadcast and
multicast messages. The default value is 1. Valid settings are between 1 and 10.
Data rate: You may select a data rate from the drop down list, however, it is
recommended to select auto. This is also known as auto fallback.
Preamble Type: Select a short or long preamble. For optimum performance it is
recommended to also configure the client device as the same preamble type.
CTS Protection: CTS (Clear to Send) can be always enabled, auto, or disabled. By
enabledCTS, the Access Point and clients will wait for a 'clear' signal before transmitting. It
is recommended to select auto.
Tx Power: You may control the transmit output power of the device by selecting a value
from the drop down list. This feature can be helpful in restricting the coverage area of the
wireless network.
4.2.6.4. Security
Encryption: Disabled
Agricultura 111 Piso 1, Colonia Escandon, Cp 11800 Mexico DF
55 52714421, 52774459, 52719163 Fax 52718216. ventas@ansel.com.mx Hoja 110 de 135
Intelligent Networking & Internet Solutions
www.ansel.com.mx