Introduction; Machine Placement - Ellison Prestige PRO Manual De Instrucciones

Introduction

® ®
Ellison Prestige Pro arrives assembled and ready to use. Prestige Pro will
cut multiple sheets of material at a time from a wide variety of products (see
Materials Guide pages 14 and 15). Prestige Pro applies the pressure to steel-
rule dies that cut through the material. The sharp cutting edge of the dies is
surrounded by rubber to help protect fingers and to eject the material that has
been cut. Place the dies (decorative shapes, letters and numbers sold
separately) in the Die Storage Racks (sold separately). See Helps and Hints for
a suggested storage method (page 9).

Machine Placement

Place Prestige Pro on a smooth, level, non-skid surface at a height that is
comfortable for the user when standing. No part of the machine should be
allowed to hang over the edge of the work surface.
Place the machine on the work surface with the side of the machine facing the
user and the front of the machine to the right (Figure A, page 5).
4