Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PLACING RATING TAG DECAL
WARNING: Information contained in the figures on this page may not be accurate or updated information.
DO NOT use any information inside of these figures for installation or technical purposes. They are only to be
used as a visual aid of how to place the decal.
After installing your new Kit #SPK100, you will need to update the information that is included on your decora-
tive/vented appliance by applying the included decal:
1. Locate the Rating Tag Decal in the Kit #SPK100packaging (See Figure 0.1)
2. Locate the Rating Tag hanging from the vented appliance (See Figure 0.2)
3. Rating Tag Decal will go where the white box is (See Figure 0.3)
4. Peel off and stick the Rating Tag Decal so it looks like Figure 0.4
5. Fill in date of conversion and name & address of company making the conversion on the
newly applied decal
Fig 0.2
Serial Number:
Company Name
Complies with ANSI Z21.84-2012, Standard
for Manually lighted, Natural Gas Decorative
Street
Gas Appliances for Installation in Solid-Fuel
City, State, ZIP
Burning Fireplaces.
Complies with ANSI Z21.60-2012, Standard
for Decorative Gas Appliances for Installa-
tion in Solid-Fuel Burning Fireplaces when
the LP Conversion Kit is installed by a
qualified technician.
0418GL009S
Minimum Fireplace Size
Log Size
Height
Depth
Front Width
18'' Vented
24'' Vented
30'' Vented
*Important: If adding a Liquid Propane Conversion Safety Pilot Kit to the burner,
8" needs to be added to the front width dimension.
WARNING:
- Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, personal injury, or loss of life. Refer to the owner's
manual provided with this heater. Installation and service must be performed
by a qualified installer, service agency, or the gas supplier.
- For installation in a solid-fuel burning fireplace only. The fireplace chimney
must have a permanent vent opening to atmosphere of not less than 50
square inches.
- A fireplace screen must be in place when the appliance is operating and,
unless other provisions for combustion air are provided, the screen shall
have an opening(s) for introduction of combustion air.
- Any glass doors shall be opened when the appliance is in operation.
Serial Number:
Company Name
Street
City, State, ZIP
0418GL009S
Rear Width
Log Size
18'' Vented
24'' Vented
30'' Vented
*Important: If adding a Liquid Propane Conversion Safety Pilot Kit to the burner,
8" needs to be added to the front width dimension.
WARNING:
- Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, personal injury, or loss of life. Refer to the owner's
manual provided with this heater. Installation and service must be performed
by a qualified installer, service agency, or the gas supplier.
- For installation in a solid-fuel burning fireplace only. The fireplace chimney
must have a permanent vent opening to atmosphere of not less than 50
square inches.
- A fireplace screen must be in place when the appliance is operating and,
unless other provisions for combustion air are provided, the screen shall
have an opening(s) for introduction of combustion air.
- Any glass doors shall be opened when the appliance is in operation.
Model
Input Rating
Gas Type
Ignition Type
Max. Inlet Pressure
Min. Inlet Pressure
Normal Pressure
This appliance was converted on _____________________ (Day-Month-Year) to LP Gas
with Kit Model# by _____________________________________________________
(Name, Address of Company making this conversion), which accepts the responsibility that
this conversion has been properly made.
Fig 0.3
Complies with ANSI Z21.84-2012, Standard
for Manually lighted, Natural Gas Decorative
Gas Appliances for Installation in Solid-Fuel
Burning Fireplaces.
Complies with ANSI Z21.60-2012, Standard
for Decorative Gas Appliances for Installa-
tion in Solid-Fuel Burning Fireplaces when
the LP Conversion Kit is installed by a
qualified technician.
Minimum Fireplace Size
Height
Depth
Front Width
Rear Width
19''
15''
24''*
20''
15''
30''*
26''
19''
20''
15''
36''*
32''
18
Fig 0.1
GLV018
GLV024
35,000 BTU/hr
45,000 BTU/hr
LP
LP
Piezo Ignitor
Piezo Ignitor
14'' WC
14'' WC
11'' WC
11'' WC
11" WC
11" WC
Fig 0.4
Serial Number:
Model
GLV018
Model
GLV018
Input Rating
35,000 BTU/hr
Input Rating
35,000 BTU/hr
Gas Type
LP
Gas Type
LP
Ignition Type
Piezo Ignitor
Piezo Ignitor
Ignition Type
Max. Inlet Pressure
14'' WC
14'' WC
Max. Inlet Pressure
11'' WC
Min. Inlet Pressure
Min. Inlet Pressure
11'' WC
Normal Pressure
11" WC
11" WC
Normal Pressure
This appliance was converted on _____________________ (Day-Month-Year) to LP Gas
This appliance was converted on _____________________ (Day-Month-Year) to LP Gas
with Kit Model# by _____________________________________________________
with Kit Model# by _____________________________________________________
(Name, Address of Company making this conversion), which accepts the responsibility that
(Name, Address of Company making this conversion), which accepts the responsibility that
this conversion has been properly made.
this conversion has been properly made.
Company Name
Complies with ANSI Z21.84-2012, Standard
for Manually lighted, Natural Gas Decorative
Street
Gas Appliances for Installation in Solid-Fuel
City, State, ZIP
Burning Fireplaces.
Complies with ANSI Z21.60-2012, Standard
for Decorative Gas Appliances for Installa-
tion in Solid-Fuel Burning Fireplaces when
the LP Conversion Kit is installed by a
qualified technician.
0418GL009S
Minimum Fireplace Size
Log Size
Height
Depth
18'' Vented
19''
15''
15''
24'' Vented
19''
30'' Vented
20''
15''
*Important: If adding a Liquid Propane Conversion Safety Pilot Kit to the burner,
8" needs to be added to the front width dimension.
WARNING:
- Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, personal injury, or loss of life. Refer to the owner's
manual provided with this heater. Installation and service must be performed
by a qualified installer, service agency, or the gas supplier.
- For installation in a solid-fuel burning fireplace only. The fireplace chimney
must have a permanent vent opening to atmosphere of not less than 50
square inches.
- A fireplace screen must be in place when the appliance is operating and,
unless other provisions for combustion air are provided, the screen shall
have an opening(s) for introduction of combustion air.
- Any glass doors shall be opened when the appliance is in operation.
GLV030
55,000 BTU/hr
LP
Piezo Ignitor
14'' WC
11'' WC
11'' WC
GLV024
GLV030
GLV024
GLV030
45,000 BTU/hr
55,000 BTU/hr
45,000 BTU/hr
55,000 BTU/hr
LP
LP
LP
LP
Piezo Ignitor
Piezo Ignitor
Piezo Ignitor
Piezo Ignitor
14'' WC
14'' WC
14'' WC
14'' WC
11'' WC
11'' WC
11'' WC
11'' WC
11" WC
11'' WC
11" WC
11'' WC
Front Width
Rear Width
24''*
20''
30''*
26''
36''*
32''
Publicidad
Capítulos
Tabla de contenido
