Operation; To Connect The Battery Charger; To Charge The Battery; Before You Operate The Product - RedMax BHT250PD60 Manual Del Usuario

• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.

To connect the battery charger

1. Connect the battery charger to the voltage and
frequency specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note: The battery will not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger will cool down the battery.

To charge the battery

Note: Charge the battery if it is the first time that you use
it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger.
437 - 002 - 02.01.2018
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.

Operation

3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
4. When all LEDs on the battery come on, the battery is
fully charged.
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note: Refer to the battery and battery charger manuals
for more information.

Before you operate the product

• Inspect the work area. Remove loose objects.
• Check the cutting attachment, see
cutter blade on page 12 .
• Make sure that the product with its safety features is
in perfect working order. Make sure all nuts and
screws are tight. Do not use a product that lacks a
part or that has been modified outside its
specifications.
• Make sure all covers is attached correctly and not
damaged before you start the product.
To examine the
9