Metrohm Spectrosense Instrucciones Para El Uso página 41

• Adapt live display
If in the live display the measured value is not shown open with a right
click into the sub window Live display the dialogue window Proper-
ties – Live display. Change the following parameters:
• Carry out adjustment
Carry out the voltage adjustment as described in Section 5.2.2.
Titrino
Connect the Spectrosense to your Titrino (see Section 2.1) and turn it on.
• Select Mode
Press the <MODE> key and then press several times the arrow key
[
following dialogue line choose, also by pressing the key [
times, the
• Start measurement
With the <MEAS/HOLD> key you can start the measurement. The
measured value is now shown on the display. To stop the measure-
ment press once more the <MEAS/HOLD> key.
• Carry out adjustment
Carry out the voltage adjustment as described in Section 5.2.2.
Spectrosense, Instructions for Use
Command type
Measured value display active
Measured value 1
] until appears. Confirm this selection with <ENTER>. In the
MEAS
measured quantity U
MEAS
Measured value
and confirm again with <ENTER>.
5 Appendix
] several
37