THERMEx Vertical 845 Manual Del Usuario página 55

1. Press button once; lights will be turn on . Press
the lights.
2. Power on: After you have connected the cooker hood to the mains supply, you can
start using the cooker hood by selecting the motor fan speed that you want,
(Low), (Medium),
3. Press the
at low speed. Press it again and the motor will stop.
4. Press the
runs at mid speed. Press it again and the motor will stop
5. Press the
high speed. Press it again and the motor will stop.
6. While the cooker hood is in use and by pressing the delay button
cooker hood will run for 5 minutes and then turn off automatically.
TROUBLESHOOTING
Fault
Light on, but motor
does not work
Light does not
work, motor does
not work
Oil leakage
Lights not working
Insufficient suction
The Range hood
inclines
(High)
(Low) button, the indicating light
(Medium) button, the indicating light
(High) button, the indicating light
Possible Cause
Fan switch turned off
Fan switch failed
Motor failed
House fuses blown
Power cord loose or
disconnected
One way valve and the outlet
are not tightly sealed
Leakage from the connection of
chimney and cover
Broken/Faulty globes
The distance between the
range hood and the gas top is
too far
The fixing screw not tight
enough
will beam, and the motor runs
will beam, and the motor
will beam, and motor runs on
Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit cord to power outlet.
Switch power outlet on.
Take down the one way valve
and seal with sealant.
Take chimney down and seal.
Replace globes as per this
instruction.
Refit the range hood to the
correct distance.
Tighten the hanging screw and
make it horizontal.
7
button again to turn off
once, the
Solution