Bimar S603.EU Folleto De Instrucciones página 21

INSTALLATION
• After unpacking, check the integrity of the appliance; if in doubt, do not use it and
contact a qualified technician. The packaging materials (plastic bags, polystyrene,
metal staples, etc.) must not be left within reach of children, as they constitute
possible safety risks and must be disposed of according to applicable regulations.
Warning: any stickers or advertising material applied to the inlet grid or air outlet or
on the base of the unit must be removed before using the appliance.
Warning: the heater must run only if its feet are correctly assembled.
To use the machine, equally assemble the two feet supplied as follows (see figures
below):
- check that the power cable is disconnected from the plug point
- Place the device horizontally on a flat, smooth surface.
- Place the feet on the heater by inserting the slots in their hooks and slide them
until they lock into place.
- Use the screws provided to secure them in place.
The device is equipped with an anti-tip system switch which "clicks" when the heater
is tilted: it is therefore normal to hear a noise inside every time you move the heater.
• Before connecting the heater check that the voltage shown on the specifications
plate corresponds to that of the electrical supply, and that the plug is effectively
grounded. In the event of incompatibility between the power supply and the plug,
have the plug replaced with a suitable model by a qualified professional, who
should ensure that the size of the cable is suitable for the power used by the unit.
The use of adaptors or extensions is generally not advisable; if it is necessary to use
them, they must comply with safety regulations and the total current (amps) must
not be rated lower than the maximum current of the the appliance.
• The plug point must be easily accessible so as to easily remove the plug in case of
an emergency.
• Place the convection heater far from any other source of heat, from flammable
material (curtains, tapestries, etc.), from flammable gases or flammable material
(spray cans) and from materials that can be deformed by heat. Make sure there is
100cm of free space in front of the heater and 50cm free space on both sides and
at the back.
• Do not use this appliance near a bath, a shower or a swimming pool; (to avoid water
droplets falling on the appliance and the appliance falling into the water); if this
happens, do not place your hand in the water but first turn off the power supply by
turning off the switch on the electrical panel, and only then remove the plug from
the plug point. Carefully dry both the plug and the socket before restoring power.
Plug into the power point and then continue using the device. If in doubt consult a
qualified professional.
21/84