Bimar S603.EU Folleto De Instrucciones página 30

Description of the heater's control panel
•
0/I switch (H) is located on the side and turns the machine on (I) or off (0)
•
Panel with a display to view the functions and a keyboard to activate the following
functions:
•
" " key (A): activates the 800W heating element and puts the device in standby
•
" " key (B): to set the four power settings: 800W/1200W/2000W/800W
(defrost)
•
"+" (E) and "-" (F) keys to adjust the ambient temperature (between 05÷37°C),
once the the set temperature has been reached, stand-by mode is activated: the
heating element is activated when the temperature falls.
•
•
" " key (C), to display Celsius or Fahrenheit degrees
•
" " key (D), to start the fan
•
The timer " " key (G) sets the time of operation, after which the unit will stop
automatically. To set the time, press the button repeatedly "
press it a different time is selected ( 1 hour - 2 hours- 4 hours ....15 hours ). To
deactivate the timer, press the button until the display time disappears. If the
timer is not activated, the device works until it is turned off.
USE
Before each use, ensure that the appliance is in good working order, and that the
power cord is not damaged: if the cord is damaged, it must be replaced by the
manufacturer or its service centre or by someone with a similar qualification in order
to prevent any risks. Ensure the air inlet and the heating element are free of dust, lint,
or anything similar: this improves the heater's performance, and prevents
overheating. Check for these conditions periodically.
Warning: before assembling, disassembling and cleaning the device, make sure it is
disconnected from the mains.
First use
Warning: run the appliance for at least a few hours to eliminate the typical smell of
new goods and any oil residue from the manufacturing process. During this operation,
ventilate the room well to eliminate the typical smell given off by the appliance.
To use the heater with the control panel keys, proceed as follows:
• Before inserting the plug in the power socket, turn the side switch to position
"0".
•
Plug into the power socket.
•
Put the switch to position "I", you will hear a sound and the display will light up
showing the ambient temperature (TEM) and the latest temperature set (SET). The
appliance is in stand-by mode and, if no key is pressed, its display turns off after 1
minute.
30/84
": every time you