Preparation; Operation Instructions - Smartpond 52285 Manual Del Usuario

PREPARATION

Before beginning assembly or operation of product, make sure
all parts are present. Compare parts with package contents list
and diagram. If any part is missing or damaged, do not attempt
to assemble, install or operate the product. Contact Customer
Care for replacement parts.
• Estimated Assembly Time: 5 minutes
• Tools required for assembly: hacksaw

OPERATION INSTRUCTIONS

Step 1. 3/4-in ID tubing is
recommended for optimum
performance. Check your
pump to determine a
compatible tubing size.
If using 1/2-in ID tubing
continue to step 2.
If using 3/4-in ID tubing, trim
the tubing adapter using
a hacksaw at the location
indicated.
If using 1-in ID tubing, trim
the tubing adapter using a
hacksaw at the top of the
widest tier.
Step 2. Place the tubing
adapter on the left hole of the
UV Clarifier and use a gasket
for it to be sealed tightly when
fastened.
Hand tighten the locking ring
outside the tubing adapter for it
to be secured in place. Repeat
for the right hole.
Step 3. Unplug your pump
from an electrical source before
connecting tubing.
Connect tubing from the outlet
of a pump to the inlet of the UV
Clarifer.
NOTE: The inlet on the UV
Clarifier is marked "IN". Pump
and tubing are not included.
4 VISIT WWW.SMART-POND.COM FOR PRODUCT INFORMATION AND TIPS.
1
2
3