Setting The Temperature Controls; Function Instruction - Samsung RW51TS338SR/AA Manual De Instrucciones

Operations

Setting The Temperature Controls

• When pressing "
upper or lower compartment automatically. The LED will flashing and display the
setting temperature. Press once the button, the temperature will increase 1℉（℃）.
When exceeding the max that can be established, it will jump to the lowest adjustable
temperature value automatically. After stopping pressing the button for 3 seconds,
LED figure will stop flash, then revert back to display the temperature of the upper or
lower actual compartment. After the unit is unplugged, the system will return to
acquiescence temperature, which setting by factory

Function Instruction

•
The default temperature setting is 54℉ (12℃) in both the upper and lower zones.
The default temperature scale is ℉
•
To switch the display between ℉ and ℃, press the upper and lower temperature
buttons simultaneously for approximately 3-5 seconds.
•
The temperature can be set as low as 45℉ (5℃) or as high as 64℉ (18℃).
•
Actual temperature inside the appliance can vary based on ambient temperature, how
often the door is opened and how many warm bottles have recently been added to
the appliance.
•
Each depression of the upper or lower temperature button will lower the temperature
of that zone in 1℃ increments
• Temperature Recollection Function
In the event of a power interruption, wine cooler can remember the previous
temperature settings, and when the power is recovery, the cooler temperature will go
back the same setting temperature as power off.
•
Overtime Open the Door Alarm
If the door is open for 2 minutes, an alarm will sound.
If the door remains open after the initial alarm, the alarm sounds every minute. Door
open alarm comes with sound and flashing lights inside.
22 English
" or " " button, the system will be entering the set up mode in the