Replacing Belt - Panasonic MC-V7314 Instrucciones De Operación

Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
Groove
Ouverture
Ranura

Replacing Belt

Lift Agitator Up
Soulever l'agitateur
Unidad del agitador
Carpet-Bare Floor
Selector Shaft
Arbre du sélecteur
tapis/plancher
Eje del selector
carpet-bare floor
End Cap
Bouchon
Tapa del
extremo
Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
Place carpet-bare floor selector in
CARPET position.
Remove lower plate.
Remove agitator by carefully lifting out.
Remove worn or broken belt.
Clean agitator and reinstall the two
(2) end caps.
Loop new belt (Panasonic Type UB8
only) around motor shaft and brush
pulley; see illustration for correct belt
routing.
Reinstall agitator back into nozzle
housing grooves.
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Reinstall lower plate.
- 34 -