Fein KBM80U Manual Del Usaurio página 15

3 41 01 126 21 0.book Seite 15 Donnerstag, 21. Januar 2010 1:48 13
Changing the tool.
Secure the power tool with the clamping strap supplied if there is danger of it fal-
WARNING
ling, especially for work carried out at a height, on vertical construction elements
or above the head. If there is a power cut, or the mains plug is pulled out, the
magnetic holding power is not maintained.
Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Core drill bit (Fig. 6).
Insert the centering pin into thee core
drill bit.
Pull the QuickIN Max.-adapter of the
tool holder downward and insert the
core drill bit together with the centering
pin.
Do not touch the sharp edges of the core drill
bit. Danger of injury.
Geared drill chuck (Fig. 7).
Turn the QuickIN adapter of the tool
holder leftward and insert the geared
drill chuck.
Drill bit (Fig. 8).
Turn the knurled nut until it spins
through.
Place the drift in position and apply a
hammer blow to remove the adaptor.
Clean the inside cone of the output
shaft and insert the drill bit.
Fig. 6
Core drill bit
Fig. 7
Fig 8
1.
3.
4.
Drill bit
en
15
QuickIN Max.
adaptor
Centering pin
QuickIN
adaptor
Geared drill
chuck
Drift
2.
Knurled nut