Leggett & Platt Performance Serie Manual Del Usaurio página 13

c. Attach one headboard bracket flange to one of the bracket channels
with (2) hex head bolts/nuts (FIGURE 9). Tighten bolts. Repeat
procedure to attach the other headboard bracket flange.
d. Slide headboard bracket assemblies (in or out) to achieve a distance of
1.5 inches (38.1mm) to 2 inches (50.8mm) between the edge of the
base and headboard bracket flange assemblies (FIGURE 9).
e. Firmly tighten the 3 inch carriage bolts of both headboard bracket
channels.
f. Measure the distance (center-to-center) between the mounting holes
in the headboard.
g. Measure the center-to-center distance between the mounting slots of
the headboard bracket flanges.
h. If bracket flange adjustment is required to accept the headboard,
remove the 1 inch headboard bracket flange bolts and move flanges
side-to-side for the adjustment (FIGURE 9). Reinstall bolts and
tighten.
i. Install headboard.
FIGURE 9
HEADBOARD
BRACKET
FLANGE
USE (2) 1 INCH LONG HEX HEAD
BOLTS AND NUTS (TIGHTEN) TO
ATTACH BRACKET FLANGE TO
BRACKET CHANNEL
STEP 11
Install mattress on adjustable base.
Typical Scape / Scape+ adjustable base installation is now complete.
INSTALLATION
Performance Models Scape/Scape+ Owners Manual 99301472-c
NOTE
TWIN SIZE HEADBOARD BRACKET
ASSEMBLIES ARE SHOWN (FIGURE
9). QUEEN SIZE HEADBOARD
BRACKETS ARE EQUIPPED WITH
ANGLE BRACES.
13