Scape Remote Control Function - Leggett & Platt Performance Serie Manual Del Usaurio

HEAD UP BUTTON
Press and hold to raise the head section.
HEAD DOWN BUTTON
Press and hold to lower the head section.
Press and hold to adjust base to the
programmed position.
*To program a position, adjust base to
desired position, press and hold the set
button until the massage motors turn on
and off, then press and hold the Cust 1
button until the massage motors turn on
Press and hold to adjust base to the
programmed position.
*To program a position, adjust base to
desired position, press and hold the set
button until the massage motors turn on
and off, then press and hold the Cust 2
button until the massage motors turn on
HEAD MASSAGE UP BUTTON
Press to increase massage intensity.
Massage has 3 speeds: Low, medium
and high. Massage will automatically
shut off after 15 minutes.
HEAD MASSAGE DOWN BUTTON
Press to decrease massage intensity.
Massage has 3 speeds: Low, medium
and high. Massage will automatically
shut off after 15 minutes.
REMOTE CONTROL REQUIRES THREE (3) AAA SIZE BATTERIES (INCLUDED). THE BUTTONS ON
THE REMOTE CONTROL ILLUMINATE FOR 2.5 SECONDS WHEN PRESSED AND RELEASED.
PRESS & HOLD TO ONE TOUCH
To change remote control functions from "press and hold" to "one touch", simultaneously press the HEAD MASSAGE DOWN and
FOOT MASSAGE DOWN buttons. The massage motor will turn on and off confirming the change. Your base is now set to "one touch."
When in "one touch" mode:
Cust 1 and Cust 2 buttons
One touch button. Base will adjust to the programmed position. Press any other button to stop the base during movement.
Flat button
One touch button. Base will shut off massage motor, if active, and adjust base to level position. Press any other button to stop
the base during movement.
To revert back to factory settings, simultaneously press and hold the SET button and the FLAT button. The massage motor
will turn on and off confirming the change. Your base is now set to factory settings.
16
Performance Models Scape/Scape+ Owners Manual 99301472-c

SCAPE REMOTE CONTROL FUNCTION

CUST 1 BUTTON
and off.
CUST 2 BUTTON
and off.
FOOT UP BUTTON
Press and hold to raise the foot section.
FOOT DOWN BUTTON
Press and hold to lower the foot section.
SET BUTTON
Press and hold to program Cust 1 and Cust
2 presets.
FLAT BUTTON
Press and hold to lower the base to the
level position.
FOOT MASSAGE UP BUTTON
Press to increase massage intensity.
Massage has 3 speeds: Low, medium, and
high. Massage will automatically shut off
after 15 minutes.
MASSAGE ON/OFF BUTTON
Press to turn both massage motors on or off.
FOOT MASSAGE DOWN BUTTON
Press to decrease massage intensity.
Massage has 3 speeds: Low, medium, and
high. Massage will automatically shut off
after 15 minutes.
NOTE
NOTE
MASSAGE SETTINGS CANNOT
BE SAVED IN PRESET CUST 1
AND CUST 2 BUTTONS.