Scape Remote Control Programming - Leggett & Platt Performance Serie Manual Del Usaurio

SCAPE REMOTE CONTROL PROGRAMMING (1 remote control - 1 base)
Program One Remote to Operate One Base - perform the
following numbered procedure.
STEP 1
Unplug the adjustable base electrical power
cord. Wait 30 seconds, then plug the cord back
into the power source.
STEP 2
Locate the control box, attached to the
underside of the base (FIGURE 15).
STEP 3
Using a pointed object, push the learn port in
two times in rapid succession. You will hear
an audible click after each push. Then, the
indicator light will light up (FIGURE 15).
FIGURE 15
STEP 4
On the remote control, simultaneously press
and hold the HEAD UP and FLAT buttons
(FIGURE 16)
until the indicator light goes off on
.
the control box
One remote control is now programmed to
operate one base.
CONTROL BOX
INDICATOR
LIGHT
LEARN
PORT
HEAD UP
BUTTON
FIGURE 16
Performance Models Scape/Scape+ Owners Manual 99301472-c
FLAT
BUTTON
17