Leggett & Platt Performance Serie Manual Del Usaurio página 18

SCAPE REMOTE CONTROL PROGRAMMING (1 or 2 remote controls - 2 bases)
Program One or Two Remotes to Operate Two Bases-
perform the following numbered procedure.
STEP 1
Plug both adjustable bases into electrical power
source. Operate both remote controls to verify each
remote functions properly with its respective base.
NOTE: see 1-to-1 programming procedure if bases
do not operate. Using remote controls, adjust both
bases to flat position. Unplug both bases from
electrical power source.
STEP 2
Choose base 1 remote. Retain base 2 remote control
as a spare or use if 2 remotes are desired to operate
both bases.
STEP 3
Position both bases on their sides, in close proximity
to each other. CAUTION: AT LEAST TWO PEOPLE
ARE RECOMMENDED FOR HANDLING AND
MOVING ADJUSTABLE BASE.
STEP 4
Locate control box on both bases. Locate dual sync
cable (FIGURE 17).
FIGURE 17
DUAL SYNC
CABLE
STEP 5
Insert one male plug of dual sync cable into
"3 Multifunction" port of control box of base 1
(FIGURE 18).
STEP 6
Insert the other male plug of dual sync cable into
"3 Multifunction" port of control box of base 2
(FIGURE 19). Note: The female plug is not used.
STEP 7
Turn both bases over so they are resting on their
legs. CAUTION: Make sure cable is clear of base
and free of any pinch points.
18
Performance Models Scape/Scape+ Owners Manual 99301472-c
OR
REMOTE 1 REMOTE 2
FEMALE PLUG
FIGURE 18
NOT USED
DUAL SYNC
CABLE
TO BASE 2
FIGURE 19
MALE PLUG
STEP 8
Plug both bases into electrical power source.
Operate both bases with either one or both remote
controls. NOTE: If bases do not operate in unison
with either of the remotes, verify dual sync cable
connections are fully seated at both control boxes.
BASE 1
BASE 2
"3 MULTIFUNCTION"
PORT
MALE PLUG
CONTROL BOX
CONTROL BOX
"3 MULTIFUNCTION"
PORT
DUAL
SYNC
CABLE