Leggett & Platt Performance Serie Manual Del Usaurio página 23

SCAPE+ REMOTE CONTROL PROGRAMMING (1 or 2 remote controls - 2 bases)
Program One or Two Remotes to Operate Two Bases - perform the
following numbered procedure.
STEP 1
Plug both adjustable bases into electrical power source.
Operate both remote controls to verify each remote
functions properly with its respective base. NOTE: see
1-to-1 programming procedure if bases do not operate.
Using remote controls, adjust both bases to flat position.
Unplug both bases from electrical power outlet.
STEP 2
Choose base 1 remote. Retain base 2 remote control as
a spare or use if 2 remotes are desired to operate both
bases.
STEP 3
Position both bases on their sides, in close proximity
to each other. CAUTION: AT LEAST TWO PEOPLE
ARE RECOMMENDED FOR HANDLING AND MOVING
ADJUSTABLE BASE.
STEP 4
Locate control box for base 1. Remove (carefully pull out)
existing cable from "3 Multifunction" port (FIGURES 25
and 26).
REMOVE
FIGURE 25
EXISTING
CABLE
FIGURE 26
REMOVE
EXISTING
CABLE
NOTE: THIS
CABLE WILL BE
PLUGGED INTO
FEMALE PLUG
OF DUAL SYNC
CABLE
"3 MULTIFUNCTION"
PORT
CONTROL
BOX
"3 MULTIFUNCTION"
PORT
CONTROL
BOX
OR
REMOTE 1 REMOTE 2
STEP 5
Locate dual sync cable (FIGURE 27).
FIGURE 27
DUAL SYNC
CABLE
STEP 6
Insert one male plug of dual sync cable into "3
Multifunction" port of control box of base 1 (FIGURE 28).
FIGURE 28
DUAL SYNC
CABLE
"3 MULTIFUNCTION"
PORT
Performance Models Scape/Scape+ Owners Manual 99301472-c
BASE 1
BASE 2
CONTROL
BOX
REMOVED
CABLE
Continued on next page...
23