Leggett & Platt Performance Serie Manual Del Usaurio página 24

SCAPE+ REMOTE CONTROL PROGRAMMING (1 remote control - 2 bases)
STEP 7
Insert male plug of removed cable into female plug of
dual sync cable (FIGURES 29 and 30).
FIGURE 29
FEMALE PLUG
OF DUAL
SYNC CABLE
MALE PLUG
OF DUAL
SYNC CABLE
FIGURE 30
24
Performance Models Scape/Scape+ Owners Manual 99301472-c
PRIOR
REMOVED
EXISTING
CABLE
DUAL
SYNC
CABLE
STEP 8
Repeat Steps 4 thru 7 with base 2.
STEP 9
Turn both bases over so they are resting on their legs.
CAUTION: Make sure cable is clear of base and free of
any pinch points.
STEP 10
Plug both bases into electrical power source. Operate both
bases with either one or both remote controls. NOTE: If
bases do not operate in unison with either of the remotes,
verify dual sync cable connections are fully seated at both
control boxes.
CONTROL BOX