Cooper Lighting MSL180 Manual De Instrucciones página 6

HOW TO REPLACE BATTERY
Note: Use only the following type and size battery: Sealed Rechargeable Lead Acid
6 Volt 4 ampere hour battery. Make sure that replacement battery is same size
(2-3/4˝ x 3-7/8˝ x 1-13/16˝) as the current battery.
1.
Turn the fixture to the OFF position and unplug the solar panel from the
connector extending from the bottom of the fixture housing.
2.
Remove fixture from itʼs mounting surface by removing the two
screws on each side of the fixture. Remove the four screws on
the back (Fig. 8).
3.
Carefully turn the fixture over and lay it on its back. Slowly lift
the front cover to the side making sure that you do not stress
the wiring.
4.
Locate the two brackets that hold the battery into place and
remove the four screws (Fig. 9).
5.
Lift battery and unplug the positive and negative leads.
Attach the leads from the fixture to the terminals of the
new battery, making sure to connect the positive lead to
the positive terminal and the negative lead to the
negative terminal.
6.
Place the battery into the fixture and replace the two
brackets that hold the battery in place, make sure that none of the wiring is
trapped under the brackets before installing any of the screws.
7.
Carefully replace fixture cover, making sure to properly seat the groove of the
top cover into the channel of the bottom cover and that none of the wiring has
been pinched.
8.
Replace the four screws in the back of the fixture.
9.
Mount fixture back to the mounting surface and plug in solar panel.
10. Allow fixture to receive four full days of sunlight before turning fixture ON.
6
Fig. 8
Fig. 9