Wiring. Pgs - Craftmade Riata Grande 70 Guia De Instalacion

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you once
you are set on the ladder.
Replace vice on safety cable and adjust safety cable length
by pulling on the cable. Adjust slack in cable to a hands
length and secure vice by tightening screw and nut
securely. The loop at the end of the safety cable should
just fit over the "J" hook. [Refer to drawing at right.]
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be
necessary to use the "J" hook (included) with the safety
cable loop. Test safety cable by pulling on loose end with
pliers. If the safety cable slips, the screw and nut on the vice
must be set tighter.
6. Wiring.
WARNING: Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch is turned
to the OFF position.
CAUTION: Be sure outlet box is properly grounded and that
a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes
or Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building wires
are different colors than those referred to below, please use a
qualified electrician.
Note: Excess lead wire length from the fan can be cut to the
desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK wire from fan to BLACK wire from ceiling
with wire connector provided.
Connect WHITE wire from fan to WHITE wire from ceiling
with wire connector provided.
Connect all GROUND (GREEN) wires together from fan to
BARE/GREEN wire from ceiling with wire connector
provided.
wood
ceiling
joist
white supply wire
black supply wire
from ceiling
black
white
white
black
from fan
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
Note: Only remote controls approved for DAMP locations
can be used with this fan.
page 5
safety cable loop
"J" hook
safety cable
hanging bracket tab
hanging ball slot
motor housing
ground
(green or bare)
ground
(green
or bare)
*