Important Safety Instructions; Basic Setup - Fellowes Powershred 99Ms Manual De Instrucciones

A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, credit cards and staples
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,
cardboard, paper clips, CD/DVDs, laminates, file folders, X-rays or plastic other than noted
above
Paper shred size:
Micro-Cut .................................................................5/64 in. x 9/16 in. (2 mm x 14 mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
to off or unplug when not in use.
openings. If object enters top opening, switch to Reverse (
products on or near shredder. Do not use canned air on shredder.
Do not place near or over heat source or water.
BASIC SET UP
CASTER INSTALLATION
1
BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after each pass
to clear entry. Continuous operation beyond
20-minutes will trigger 40-minute cool down period.
2
F.
G.
KEY
A. SafeSense
B. Paper entry
C. See safety instructions
D. Pullout bin
E. Casters
F. Disconnect power switch
2 3
PAPER OR CARD
1
Plug in and put
disconnect power
switch in ON (I) position
Technology G. Control Panel and LEDs
®
1. Overheat (red)
2. Bin open (red)
3. Bin full (red)
4. Remove Paper (red)
5. SafeSense
6. Reverse
1. OFF
7. ON/OFF (blue)
2. ON
8. Forward
Maximum:
Sheets per pass ........................................................................................................... 14*
Paper entry width ........................................................................................9 in. (230mm)
* 8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 6.5Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 1000 sheets per day,
50 credit cards. 14 sheets per pass to avoid jams.
Fellowes SafeSense ® shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
) to back out object.
voltage and amperage designated on the label. The grounded outlet or socket
transformers, or extension cords should not be used with this product.
4
2 2 3
Feed paper/card
Press ON (I) to
straight into paper
activate (blue)
entry and release
indicator (yellow)
®
5
4
When finished
shredding set
to OFF ( )
ENGLISH
Model 99Ms
( )