Electrical Connection - Wolf E Serie Guia De Instalacion

IN S TA L L AT I O N
Preparation
Before moving the oven, protect any finished flooring and
secure the oven door(s) closed to prevent damage.
Use an appliance dolly to move the oven near the opening.
Remove and recycle packing materials. Do not lift or carry
the oven by the door handle.
CAUTION
Do not lift the oven by the door handle. This will
damage the oven door and hinges.
O VEN DO O R RE M O VA L
To lighten the load or to fit through a doorway, the oven
door(s) can be removed. Remove only if necessary. Door
removal should be done only by a certified installer or ser-
vice technician.
To remove, open the oven door completely. Rotate both
hinge latches forward to the open position, then lift the door
up and out. Refer to the illustration below.
To reinstall, insert the door hinges into the frame openings,
then rotate the hinge latches to the closed position.
CLOSED
OPEN
Oven door removal
|
10 Wolf Customer Care 800.222.7820

Electrical Connection

WARNING
Verify power is disconnected from the electrical box
before proceeding.
With the oven positioned directly in front of the opening,
feed the conduit through the opening in the cabinet platform
(if applicable). Depending on local codes, connect the oven
to the electrical supply following these steps for a three-wire
or four-wire system:
Connect the black appliance wire to the black (L1) power
1
supply wire in the electrical box.
Connect the red appliance wire to the red (L2) power
2
supply wire in the electrical box.
Connect the ground appliance wire to the green/ground
3
house grounding wire in the electrical box.
For a four-wire system, leave the white neutral wire in the
4
house electrical box unconnected. Seal with a wire cap.