Cosatto SUPA NITTY GRITTY Manual De Instrucciones página 5

The harness can be removed for cleaning purposes. To remove the shoulder strap & crotch straps
push plastic clips through from the rear of the seat unit (f) & (g). To remove the waist straps, first
unfasten the webbing by feeding the edge of the webbing through the opening of the metal clip
(h) and push the metal clips through from the rear of the seat unit.
To refit the harness reverse instruction above.
7 - fitting the softgoods
To fit the footmuff unfasten the harness and remove the chest pads and headhugger by unclipping
the shoulder straps from the buckle and sliding off the chest pads and headhugger (a).
Pass the harness straps through the slots in the footmuff and seat liner (b, c & d).
Attach the fastener straps (e) at the top of the footmuff to the back of the seat.
Slide the headhugger and chest pads back onto the shoulder straps and re-fasten the buckle.
8 - using the backrest
The backrest can be adjusted in four different positions. To lower the backrest, simply lift the
lever behind the backrest. The backrest will drop down automatically. To raise, push the
backrest upwards from the centre to the required angle: it will lock into place automatically.
9 - using the calf support
To lower, lift both the levers (on lower part) forward whilst simultaneously pushing the calf support
downward. To raise, just pull the calf support upward and it will automatically lock into place.
10 - removing the basket
Your basket is removable for easier cleaning. To remove your basket, undo the four straps, two
either side. To re-fit your basket, simply reverse the above process. Maximum load 2kg (4lb) of
goods, evenly distributed.
11 - fitting the hood
To fit the hood, place the back behind the seat (a), clip the brackets into the mountings on the
chassis tubes (b) and push down as shown until they lock in place. Attach the fastener loops on
either side of the hood to the front leg tubing (c).
Attach the fastener tabs to the seat on each side (d). Fastener tabs at the bottom of the hood
attach to the back of the seat when the backrest is in its lowest position.
To remove the hood release the fastener tabs and loops, press the levers under the hood
mountings (e) then lift the hood clear.
12 - using the hood
To raise the hood, pull the top of the hood forward (a) until it locks in position.
To lower the hood, simply push the hood back (b).
To extend the hood, unfasten the zip (c) around the rear frame of the hood then pull the front of
the hood forward (d). To close the extension, push the front of the hood back and refasten the zip.
13 - using the multimedia pockets
A speaker is fitted at the rear hood pocket for connecting to media player.
The flap covering the rear pocket can be raised (a) to reveal the window in the back of the hood.
Place the speaker, facing towards the seat, into the inner pocket (b). Holes in the speaker identify
the front face (c). Feed the jack plug through the hole in the inner pocket (d). Connect the jack
plug to your media player (not supplied) and place your media player in the rear pocket.
Note: The speaker is intended to be used only when fitted correctly in the inner pocket.
Note: Only use the speaker supplied or an official Cosatto replacement.
A pocket for a tablet computer is located in the front section of each hood.
To fit your tablet computer (not supplied) pull back the flap (e) and carefully slide the tablet into
position (f). Once in place fold the flap back to cover the open end of pocket.
Note: Please ensure the open end of the pocket is covered at all time even if pocket is not in use.