Kohler K-8002 Guía De Instalación Y Cuidado página 8

4.
Install the Finished Wall
4" (10.2 cm) –
4-1/4" (10.8 cm)
4" (10.2 cm) –
4-1/4" (10.8 cm)
Cutout
Découpe
Abertura
Install the water-resistant wall board.
Cut out a 4" (10.2 cm) to 4-1/4" (10.8 cm) square at each tile installation location.
Install the finished wall material.
Installer le mur fini
Installer le matériau du mur résistant à l'eau.
Découper un carré de 4" (10,2 cm) à 4-1/4" (10,8 cm) à chaque emplacement
d'installation de carreau.
Installer le matériau du mur fini.
Instale la pared acabada
Instale el panel de yeso para pared resistente al agua.
Corte un cuadro de 4" (10,2 cm) a 4-1/4" (10,8 cm) en el lugar de instalación de
cada azulejo.
Instale el material de acabado de la pared.
5.
Verify Depth and Install the Pipe Nipple
Remove the nipple.
NOTE: The minimum distance between the face of the tee/elbow and the surface of
the finished wall should be 2-1/4" (5.7 cm). The measurement for typical installations
is 2-3/4" (7 cm).
Measure the distance from the face of the tee/elbow to the surface of the finished
wall. Make any adjustments as needed.
If your measurement is 2-1/4" (5.7 cm): Use a close pipe nipple.
If your measurement is 2-3/4" (7 cm): Use a 1-1/2" pipe nipple.
Thread the nipple into the tee/elbow and hand tighten.
1095094-2-A
Tee (or Elbow)
T (ou coude)
T (o codo)
2-1/4" (5.7 cm) Min
8
Finished Wall
Mur fini
Pared acabada
Nipple
Mamelon
Niple
4" (10.2 cm) –
4-1/4" (10.8 cm)
Kohler Co.