Buggypod lite Manual De Montaje página 3

Fitting Check List
PLEASE READ BEFORE CONTINUING
• The Buggypod ® lite can be attached to most buggies and pushchairs including twin pushchairs
and 3-wheelers. The mounting bracket strap can be tightened easily around most buggy
and pushchair frames. The frames can be oval, square, round, thick or thin.
• Looking at the pushchair from the rear or the front, the bars to which you intend to
attach the brackets must be vertical; otherwise the Buggypod
• The mounting brackets should be attached to two major frame bars on the right hand
side of your pushchair (when viewed from the pushing position) between 29 - 41cm
from the floor and 14cm- 37.5cm apart.
PARALLEL FITTING
For correct installation, the mounting brackets
(Part e- see Components on page 2) need to be
positioned to allow the connector bar (c) to run
parallel to the centreline of the host pushchair.
If this is not possible, (e.g. with some 3 wheeler pushchairs),
the connector bar adaptor (d) *can be used to
ensure the connector bar is able to run parallel
to the centreline. Please see page 10 for instructions
on how to install the Buggypod
connector bar adaptor.
• You should check that, once fitted, the mounting brackets do not prevent you from
using the pushchair brakes or folding the pushchair.
For more information visit www.buggypod.com
* Available separately
® lite will not sit vertically.
® lite when using the
1